Публикация: 01. февраля 2024 ktpe_newsdate_updated: 29. марта 2024

Shrinkage values in accordance with DIN EN ISO 294-4


Shrinkage can be measured for any Shore hardness.


During the industrial processing of plastics, details of their shrinkage values form part of the standard information that is essential as a specification for mold construction. To provide manufacturers with maximally precise data, KRAIBURG TPE has been using a contactless optical measuring device since August 2023, which enables distance measurements required to determine shrinkage values in accordance with DIN EN ISO 294-4.

 

Waldkraiburg, February 2, 2024 – The measurements “for determining the processing shrinkage and the post-shrinkage of thermoplastics” are based on test specimens 60 x 60 x 2 mm in size that are injection-molded in accordance with the DIN standard, for which the values are determined. During measurements, shrinkages are determined both along the direction of flow and transverse to it.

 

Combined with other parameters such as wall thicknesses and flow paths, these specifications enable mold makers and calculation engineers to carry out specific calculations for the most accurate dimensioning of their molds. This applies to the manufacture of new molds, but also to adjusting existing molds, e.g. for planned material changes. In all cases, the cavity must be designed in such a way that the material shrinkage, that persists for up to 48 hours after processing, is taken into account in relation to the finished plastic part.


“We previously determined the shrinkage values by using tactile measuring devices,” summarizes Grit Müller of Team Application Engineering at KRAIBURG TPE. “The use of contactless measuring devices has proved to be advantageous, particularly for measuring the shrinkage of soft and very soft materials.” The reason for this, she adds, is that “When using mechanical devices, measurement distortions may occur due to minimal compressive loading, which in turn leads to minimal deviations from the dimensions required for the finished plastic after processing.” According to Grit Müller, the conditions required for using the new optical measuring device – i.e. expanding the in-house test plate production by integrating another insert into the new master die (including internal pressure sensors) – were already established last year.

 

Since the introduction of the new contactless measuring device, KRAIBURG TPE has been able to determine shrinkage values for all established compounds in accordance with the DIN EN ISO 294-4 standard, irrespective of the Shore hardness of the tested materials. This enables both existing customers and also potential new customers to make decisions on the use of new or alternative materials based on even more precise information. This is of particular relevance for the production of single-component materials, since in these cases it is only the TPE source material that shrinks. But it also makes it possible to better assess the impact on shrinkage in two-component composites.


ktpe_get_assets

ktpe_get_assets_description

01.02.2024ktpe_mediapack Shrinkage values in accordance with DIN EN ISO 294-4

Latest News

Our Communication team is happy to assist you.

If you have any questions or would like more information, please contact our press spokesperson.

Bridget Ngang

Juliane Schmidhuber

Mirna Pina